FPV Camera & Phone Mount Bracket for MoFly P-51D & MF-A84 690mm Warbirds

FPV Camera + Phone Mount Kit for MoFly P-51D / MF-A84 (690mm)

This all-in-one kit includes a lightweight FPV camera and an adjustable phone holder mount designed specifically for the MoFly P-51D 690mm and MF-A84 690mm warbirds—so you can fly FPV, record onboard footage, or do quick ground checks with your phone.

Key Features

• Purpose-built fit: Mount geometry and hole spacing match the MoFly P-51D and MF-A84 for a clean, secure install.

• Two capture options included: Use the mini FPV camera for immersive flights or switch to the phone holder for simple onboard/ground recording.

• Stable footage: Rigid side plates and anti-slip pads help reduce vibration and camera shake.

• Balanced placement: Centerline alignment helps maintain CG; adjust your flight battery if needed.

• Quick setup: Installs with basic tools in minutes; reusable hardware.

Compatibility

• Full compatibility:

  • MF-A84 690mm RC Warbird

  • MoFly P-51D 690mm Brushless RC Warbird

• May fit with light mods: Other 650–700 mm EPP warbirds with similar fuselage width and M2/M3 mounting points.

What’s in the Box

• 1× Mini FPV camera unit (lightweight, wide-angle)

• 1× Adjustable phone mount cradle

• 2× Carbon-fiber side plates (L/R)

• Mounting screws & washers (model-specific lengths)

Note: Phone, video transmitter/receiver, and wiring harnesses are not included unless otherwise stated by your aircraft package.

Recommended Payload

• FPV cam: micro/nano class (typically ≤30–40 g).

• Phone: compact/light models ≤120 g; secure with strap/elastic and enable airplane mode.

Quick Install (2–5 Minutes)

1. Open canopy; check battery position for CG headroom.

2. Align side plates with factory holes; lightly thread screws.

3. Attach camera or phone cradle; tighten evenly.

4. Do a gentle shake test, then a short glide/power-on test.

5. Shift battery as needed to restore CG before full-power flight.

Safety & Tips

• Always re-check CG after mounting accessories.

• Use a low-profile lens to avoid prop wash and reduce drag.

• Record at wide angle and higher frame rate for smoother footage.

• Inspect screws after the first few flights.

More for MF-A84

Looking for propellers, landing gear, or spares?
➡️ MF-A84 690mm Spare Parts Collection

Specs (Mount & Camera)

• Materials: Carbon-fiber side plates, composite/TPU cradle, alloy camera housing

• Interface: Multi-hole pattern for M2/M3 hardware

• Finish: Matte, anti-glare

• Total kit weight (approx.): ≤25–45 g (hardware included)

Support

Questions about fit or setup? Message us—our team will help you get airborne with confidence.